BHT Engineering Ltd

Spindle Dia 100mm with 50 Int Spindle Nose. Rotary Table 1250mm x 1250mm.

Spindle Dia 100mm with 50 Int Spindle Nose. Rotary Table 1250mm x 1250mm.

Capacity:- Max Diameter Swing Over Bed 909mm (35.5") Max Distance Between Centres 7315mm (24 Feet) * See Note. Max Dia Swing in Gap 1345mm (53"). Spindle Speeds 12.8 to 643RPM

Imperial Machine. Swing over Bed 535mm x 2540mm B.C. (21" x 100")

Imperial Machine. Swing over Bed 390mm x 1250mm B.C. (15" x 50")

Imperial Machine. Swing over Bed 460mm x 1500mm B.C. Swing in Gap 730mm.

Imperial Machine. Swing over Bed 330mm x 750mm B.C. (13" x 30")

Spindle Dia 80mm with 5 Morse Spindle Nose. Rotary Table 1255mm x 1120mm.

Arm Radius 1828mm. Spindle Nose No 5 Morse Taper. With Box Table & Spindle Brake. Speeds 12 to 1000 RPM

Table 1000mm x 250mm. Spindle Nose 40 Int. With Power Table Feeds

Table 1250mm x 315mm. With Swivelling Vertical Milling Head - Spindle Nose 40 Int.

Table 457mm x 152mm (18" x 6") Magnetic Chuck 350mm x 150mm

Wheel dia 180mm. Magnetic Chuck 255mm x 125mm.

Capacity 300mm. With Roller Tracking

With Rotary Table - 457mm (18") Diameter

Capacity Approx 100 Tons. Throat 381mm (15")

Band Width 150mm.

Each 1520mm High x 300mm Wide x 660 mm Length of Base

760mm High x 1370mm Wide x 375 mm Length of Base

Throat 609mm (24")With Blade Welder

1 HP

With Compound Table 565mm x 245mm

Single Phase. Capacity 13mm. Requires Attention

With Leads & Gun

Single Phase

Plus Drill Chuck

Range 0-12"

Range 12"-13", 13"-14", 14"-15", & 15"-16"

Range 2"-15"

Range 2"-8"

Range 0-2" & 5"-6"

Record - No 25, 36 & 3VS

Untested

Granite 460mm x 305 & CI 300mm x 300mm

Untested

Not Vice Shown in Photograph

Not Vice Shown in Photograph

Large Plate 930mm Wide x 770mm x 400mm

Automaticaly Feeds 3M Roll Past Plastic Polishing Pad

Untested

Steadies - Two off Three Point Fixed & One Travelling